Z-Wave Plus Secure Wall Thermostat with LCD display Q&A
Activity timeframe
confusion regarding model View answer
Asked 2 ´years ago
Hi there, I'm looking for a Z-wave dry contact switch, connected to my existing pilot wires from the boiler. Not really fussed about it being a thermostat, as all I need is to be able to remotely turn the heating on or off. I don't want to have to change out anything with the existing boiler's timer / programmer. I intend to leave it heating turned on at the boiler indefinitely, and the dry contact switch as the main on-off. I can then use scenes to control timing if need be. I don't think this Secure product is built for that since it needs replacing the boiler's timer / programmer. Can you kindly recommend a suitable product? Thanks in advance. View answers
Asked 7 ´years ago
Can this unit be used to trigger events in a controller (in my case the Homeseer Hometroller Zee S2) rather than being paired with a boiler receiver? I have two electric radiators in a room, and want to turn them on and off based on the thermostat reading. So I would create the various events to change the set point in the Homeseer, but also want the thermostat to trigger the events which turn the radiators on and off. Would that work, or should I be looking at something else? View answers
Asked 8 ´years ago
I currently have have 1x SRT321 thermostat and 1x SSR303 actuator and ordered a bunch of LC-13 TRV's - however I would need to be able to trigger the boiler if the temperature drops in a room other than where the main SRT321 is located. If I understood the manuals correctly, I shouldn't send the trigger command from my Vera because the SSR303 will go into fail-safe mode if the trigger isn't re-sent within the next hour. So I guess ideally one (or more) SRT321 should be managing the SSR303? So my question is: can multiple SRT321 thermostats be paired with a single SSR303 actuator? View answer
Asked 8 ´years ago
I am thinking of buying a srt 321 to manage two electric radiators that have one zwave switch each. Is it possible to associate TWO nodeids in group 2 (on/off group) with the thermostat? Some forums say that you only can associate with one nodeid. Yes, I know that I can create scenes and automations in the controller, but I would like to do it locally as it is in the guesthouse and communication is not always reliable. View answer
Asked 4 ´years ago