Has anyone figured out how to set the light and humidity thresholds? The manual gives parameter values, sizes and hex/decimal descriptions but setting them don't match and the default values don't match the ones in the manuals, they aren't even close. Trying to set values gives me "Failed to set user settings" in my Vera Edge. View answers
Asked 8 ´years ago | Z-Wave Plus Aeotec MultiSensor 6
Does this stick battery prevent it from forgetting the network routing? I bought the UZB and whenever i unplug it from the pc or just reboot the pc, all routing is reset and it starts all over again resulting many times in dead nodes.. Is this the correct behaviour? Dow the Aeon stick do the same? View answers
Asked 8 ´years ago | Aeotec Z-Stick Gen5 USB Controller (NEW Raspberry Pi 4 compatible)
Can this unit be used to trigger events in a controller (in my case the Homeseer Hometroller Zee S2) rather than being paired with a boiler receiver? I have two electric radiators in a room, and want to turn them on and off based on the thermostat reading. So I would create the various events to change the set point in the Homeseer, but also want the thermostat to trigger the events which turn the radiators on and off. Would that work, or should I be looking at something else? View answers
Asked 8 ´years ago | Z-Wave Plus Secure Wall Thermostat with LCD display
Hi all. I have a garden office heated by an electric oil filled radiator which I control with a ZWave socket. I use the temperature sensor in a movement sensor, and I link the two with a software thermostat on a Vera Lite. It works, but I'd prefer to have something where I can physically override the temperature and visually see what the current setting is. This unit looks ideal, but can it be made to switch my simple on/off ZWave socket? And can I set a schedule by simply getting my Vera to set the temperature according to my schedule, rather than using the unit's built in timer? Thanks in advance, Andrew. View answer
Asked 8 ´years ago | Z-Wave Plus Secure 7 Day Programmable Room Thermostat
Asked 8 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus
Normally when I think about DIN rails, I think about the 2 pole fuse/breakers in my house consumer unit. Where do these fit in ? Do they go in the same unit, next to the breaker for say the lighting ring/circuit I want to control/dim? Or do you recommend they go into a different unit - away from the main breakers etc? View answer
Asked 8 ´years ago | Z-Wave Qubino Din Dimmer Gen5
Can the Qubino door sensor be connected into this and does it show as a operate sensor in the Z-wave control panel (Vera in my case)? I'm weighting up all my options for controlling a gate and this seems perfect if it runs from 24v and can have the door sensor connected directly into it as well. Less items to need to wire up View answers
Asked 8 ´years ago | Z-Wave Qubino Flush 1D Relay Plus
How do you use this module? View answers
Asked 8 ´years ago | Qubino Temperature Sensor
Does this control 2 loads separately? View answers
Asked 9 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus
Will this work with Smartthings? View answer
Asked 9 ´years ago | Z-Wave Philio Smart Colour Button Gen5
Hi. Is it compatible with Fibaro HC2? View answer
Asked 9 ´years ago | Z-Wave Philio Smart Colour Button Gen5
Is this MultiSensor 6 in EU Frequency? View answers
Asked 9 ´years ago | Z-Wave Plus Aeotec MultiSensor 6
Can the sensitivity be set so pets are ignored? View answers
Asked 9 ´years ago | Z-Wave Plus Aeotec MultiSensor 6
