What connectors do I need to order to extend this cable? I can get them from Farnell or RS if I know what are used. I'm assuming that this is a 1-wire sensor as it has three wires, pwr, gnd and the 1-wire bus, and that means that it can be extended to quite a few metres and I need to pick up the outside temperature... View answers
Asked 7 ´years ago | Qubino Temperature Sensor
Does this item work with Fibaro HC2 please View answer
Asked 7 ´years ago | Z-Wave Popp Z-Rain
I read the following in the manual: Rated output power 8A for single output channel,13A at max.(3,25A for R.G.B.W. single output channel is suggested) I'm planing to control two strips of LED with the RGBW-Dimmer. Using two of the four channels. How much power (current) can each of the two LED-strips have? (I'm using a 24V driver). Maybe 13A/2 = 6.5A per channel? View answer
Asked 7 ´years ago | Z-Wave Qubino RGBW Dimmer Plus
Asked 7 ´years ago | Z-Wave Plus Aeotec MultiSensor 6
Does this use the European or USA Z-wave frequency? View answer
Asked 8 ´years ago | Z-Wave Plus Secure Wall Switch
QNAP, OpenHAB + Aeon Labs Z-Stick USB, possible? I'm guessing this is possible, there is a package for OpenHab that will install on QNAP, so if I stick this USB stick into the back of the QNAP box will I be good to go? View answer
Asked 8 ´years ago | Aeotec Z-Stick Gen5 USB Controller (NEW Raspberry Pi 4 compatible)
Multiple questions --> What is the difference between the bi-stable and the contactor switch ? I need to switch a load of ~ 4k W (electrical water heater) which uses a double switch (live+neutral), which one suits better ? Do u have any feedback from Vera users that have managed to add them in their network (smart meter, contactor, bi-stable) ? View answer
Asked 8 ´years ago | Qubino 32A Bistable Switch for Smart Meter
Can this device with Fibaro Home Centre 2? View answers
Asked 8 ´years ago | Z-Wave Qubino Flush Shutter DC
I currently have have 1x SRT321 thermostat and 1x SSR303 actuator and ordered a bunch of LC-13 TRV's - however I would need to be able to trigger the boiler if the temperature drops in a room other than where the main SRT321 is located. If I understood the manuals correctly, I shouldn't send the trigger command from my Vera because the SSR303 will go into fail-safe mode if the trigger isn't re-sent within the next hour. So I guess ideally one (or more) SRT321 should be managing the SSR303? So my question is: can multiple SRT321 thermostats be paired with a single SSR303 actuator? View answer
Asked 8 ´years ago | Z-Wave Plus Secure Wall Thermostat with LCD display
Has anyone figured out how to set the light and humidity thresholds? The manual gives parameter values, sizes and hex/decimal descriptions but setting them don't match and the default values don't match the ones in the manuals, they aren't even close. Trying to set values gives me "Failed to set user settings" in my Vera Edge. View answers
Asked 8 ´years ago | Z-Wave Plus Aeotec MultiSensor 6
