Question 1

Can this be connected to two bell-push switches, to activate two lighting scenes? The lights would be powered by other zwave modules (dimmers), so these would purely be used to trigger the scenes. View answer

Asked 7 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 2

hi is this light dependent . ie only work at night ? also does it work with n-cube controller?

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 - Gen5

Question 3

Hi, I had successfully setup 1x MultiSensor 6 (ZW100-C) which required a change of device type. I then purchased 2 more (same model, same firmware) but they have aren't detecting any motion. Is there any advice on how to resolve this? I have tried a number of different DTH, removing and repairing etc and now looking for some help.

Asked 7 ´years ago | Z-Wave Plus Aeotec MultiSensor 6

Question 4

Are there any special instructions for including this in a Vera Edge system. It seemed to install but will only notify about tampering and has no apparent reaction to movement other than a small fashing led. No notifications.

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 - Gen5

Question 5

Does this work with Vera Edge ?

Asked 7 ´years ago | Z-Wave Philio Multisensor - Door / PIR / Light / Temp - Gen5

Question 6

how do these perform with metal back boxes? Is there a significant reduction in effectiveness / range? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 7

Is this product working with VERA Plus - UI7? Any experiences with the setup and compatibility? View answer

Asked 7 ´years ago | Home Assistant Compatible > Z-Wave Remotec AC IR extender

Question 8

Is it possible to change colors of the light bulb using smartthings View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 9

Does this need ventilation? I was planning on using these in the loft for the upstairs lighting and putting them in PVC boxes along with any connectors etc. This is to keep things neat and safe but wondered if I need to drill holes in the boxes for ventilation? View answers

Asked 7 ´years ago | Z-Wave Fibaro Universal Dimmer 2

Question 10

If I mount this in a roof, what's the max angle that it can be moved to in the horizontal & what's the andle of detection?

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 with Round Recessor - Gen5

Question 11

How is the quality of the key chain? It looks very frail as seen from the picture. I just wonder how long time it would survive in my keys View answers

Asked 7 ´years ago | Z-Wave Fibaro KeyFob

Question 12

Does this work on the standard European 868 zwave frequency ? View answer

Asked 7 ´years ago | Z-Wave Vision Door Lock without Handle

Question 13

What is new from the previous version. Looks pretty the same View answer

Asked 7 ´years ago | Z-Wave Fibaro Universal Door & Window Sensor 2

Question 14

hello, does anyone know if this can be used with a fibaro hc2 and does it do anything else like lux, temp or humidity. thanks View answers

Asked 7 ´years ago | Z-Wave Philio Motion Sensor PSP05 - Gen5

Question 15

The uses states security gates, does this mean it's waterproof and suitable for outdoor use now? View answers

Asked 7 ´years ago | Z-Wave Fibaro Universal Door & Window Sensor 2

Question 16

Will it still accept an external temperature probe like the original model? View answer

Asked 7 ´years ago | Z-Wave Fibaro Universal Door & Window Sensor 2

Question 17

Hi. What wireless switch could I use with this dimmer? And do I need a 3rd party device (e.g. Vera or Smartthings) to configure them to talk to each other? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 18

Hi, will two of these fit in a two gang wall box? I have both pendant and wall lights in my lounge View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 19

Use for a UK 2-wire (No neutral) switch with a 13W LED non-dimmable bulb in hallway, do I need to install with the bypass 2? View answer

Asked 7 ´years ago | Z-Wave Fibaro Universal Dimmer 2

Question 20

Will this work with the latest Aeotec Nano Dimmer for which does not have a bypass available yet? I cannot beleive that the internals will be much difference between provisors - basically some additional resistance and capacitance added. Has anyone tied this and can report compatability? View answer

Asked 7 ´years ago | Z-Wave Fibaro Dimmer Bypass 2

Question 21

Will this work with a PWM Immersion heater (ie. one that can very it's power). Other meters give false readings for me when it's on.

Asked 7 ´years ago | Z-Wave Plus Aeotec Clamp Power Meter - Three Clamps (60A)

Question 22

Can this be used as four separate 36w 12v channels? I want to control four sets of 12v led lamps but am not sure if it can only be controlled as if it were colour, so I would have to choose, for instance, yellow, to have two sets on? View answer

Asked 7 ´years ago | Z-Wave Qubino RGBW Dimmer Plus

Question 23

Hi Vesternet team, If i add a schedule in the Z-wave controller and eg my wife add a schedule on the thermostat than what happens? View answers

Asked 7 ´years ago | Z-Wave Plus Secure 7 Day Programmable Room Thermostat

Question 24

Can you confirm that S2 can control a second lighting circuit alongside one on S1? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 25

In the US they sell a touch display that plugs directly into this module but its the wrong size for the UK. Does anyone know if they will sell a UK version? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 26

Can this module be used behind a standard UK Socket and control/monitor it? View answer

Asked 7 ´years ago | Z-Wave Fibaro Double Switch 2

Question 27

What does the physical switch attached to this device do? does it activate the dimming or does it just enable/disable the whole device? Forgive the naiivety of the question, I'm still a noob at this View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 28

Manual says it transmits every 15mins in Normal mode. But does the message contain multiple readings or only a single reading covering the entire 15mins. I am after history with lower granularity, say 1min, but don't want to drain battery with Real-Time mode.

Asked 7 ´years ago | Z-Wave Data Logger for E-Meters

Question 29

Will this work with the new smart gas meters. (EDF have installed a Flonidan branded Smart Gas Meter but it cannot connect to the mobile telephone network so cant get at the data)

Asked 7 ´years ago | Z-Wave Data Logger for E-Meters

Question 30

What's the difference between this model (FIBEFGS-223) and the FIBEFGS-222? One is described as a switch and the other as a relay, but otherwise seem identical. Does it make any difference to what it can do? I want to use them behind existing light switches to control lighting circuits - does it make any difference which I use? Thanks! View answers

Asked 7 ´years ago | Z-Wave Fibaro Double Switch 2

Question 31

How is this better than the Fibaro Dimmer 2 (which I just bought)? "outperforms all that has come before it" is quite a grand claim - is it just compatible with a broader selection of LED bulbs? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 32

Does this have Low Battery Alert? View answers

Asked 7 ´years ago | Z-Wave Fibaro Flood Sensor

Question 33

Does this work with Samsung SmartThings Hub? View answers

Asked 7 ´years ago | Z-Wave Fibaro Flood Sensor

Question 34

Which bypass do you recommend & stock, for use with lighting loads below 4 watts? View answer

Asked 7 ´years ago | Z-Wave Plus Aeotec Nano Dimmer

Question 35

Please can you recommend other night latches which are compatible with the keyless smart lock. This is the only one Yale lists as compatible but I do not like it.

Asked 7 ´years ago | Yale Smart Living Y3 Contemporary Nightlatch

Question 36

I am looking for a Z-Wave Plus LED controller that has DMX512 output. Does this device or do you know of any others that fit the bill please? View answer

Asked 7 ´years ago | Z-Wave Qubino RGBW Dimmer Plus

Question 37

Has anybody seen an issue where the Q outputs don't follow the S inputs? I have to toggle the state of the input switch a few times to get it to sync up. The input switch is the microswitch on my Heating Control Valve. View answer

Asked 7 ´years ago | Z-Wave Fibaro Double Switch 2

Question 38

I am using a pir to switch this on which seems to work but it keeps showing as device not detected! I'm using Vera edge is there a parameter I need to change or is it not compatible thanks View answers

Asked 7 ´years ago | Z-Wave Fibaro Single Switch 2

Question 39

When will Aeotec Wallmote double be available for UK installation & quad back in stock? View answers

Asked 7 ´years ago | Z-Wave Plus Aeotec WallMote Quad

Question 40

Does this have the possibility of manual override in case Z-wave is down? I don´t see a button View answer

Asked 7 ´years ago | Qubino 32A Contactor for Smart Meter

Question 41

It says "For use with Qubino Smart Energy Meter". Is the Smart Meter a requirement to use this contactor or can it be used without it? View answers

Asked 7 ´years ago | Qubino 32A Contactor for Smart Meter

Question 42

Can this be controlled locally via SmartThings if there is no internet connection? It is possible to link a Z-Wave remote to it directly? View answers

Asked 7 ´years ago | Z-Wave Plus Aeotec Smart Switch 6 - UK

Question 43

Does this device work fully with HomeSeer? View answer

Asked 7 ´years ago | Z-Wave Fibaro Double Switch 2

Question 44

Would there be a minimum GU10 number of lights that would not need a Fibaro dimmer 2 ? I have a number of circuits with GU10 lights 6W X 9 in a kitchen and out in a hallway 2 way circuits of 2 each by 2 and a circuit of 4. Would I need a dimmer bypass then for all circuits. View answer

Asked 7 ´years ago | Z-Wave Fibaro Universal Dimmer 2

Question 45

Does anyone know if this unit is stable with HomeSeer? I have a couple of the Fibaro Dual Relay units but their status reporting is flaky at best and I cannot rely on them. - Thanks! View answer

Asked 7 ´years ago | Z-Wave Qubino Flush Relay x 2 Plus

Question 46

Hi - when wired this into a double switch and then included this with a Vera Plus controller there were 3 devices created - the master and 2x appliance modules. In Vera only using the master switch has an affect and it only controls one of the switches. How do I include this so that both switches are controlled? View answer

Asked 7 ´years ago | Z-Wave Fibaro Double Switch 2

Question 47

I have a set of motorised curtains which run off 12V DC. Can I use this device to control them? It has a 4-wire input in addition to the 12C DC power socket: Green:Close/Open, Red:Open/Close, Yellow:Stop, Black:Neutral. View answers

Asked 7 ´years ago | Z-Wave Qubino Flush Shutter DC

Question 48

Is this compatible with Vera Edge please? View answers

Asked 7 ´years ago | Z-Wave Plus Secure SES302 Temperature Sensors Gen5

Question 49

The blurb on this product says you can connect an external probe, but one is not supplied. The picture shows a very neat looking probe. Can anyone recommend a specific (and cost effective) probe that is known to work with this sensor? View answer

Asked 7 ´years ago | Z-Wave Fibaro Flood Sensor

Question 50

Can this unit be controlled by other Z-wave controllers? Is the Smart Meter required for it to function?

Asked 7 ´years ago | Qubino 32A Contactor for Smart Meter

Browse by Topic

Tools