Answer
Oct 31, 2016 - 02:36 AM
This should work fine, all you are doing is having the Fibaro relay control the high power relay. So long as the double pole relay is 230VAC it will be fine.
I want to use a Fibaro relay to swicth an immersion heater on and off. The load is switched using a double pole relay. Can I simply connect the Fibaro output across the relay energising contacts, or will you need a resistor in series to reduce the current? Z-Wave Fibaro Double Switch 2
I want to use a Fibaro relay to swicth an immersion heater on and off. The load is switched using a double pole relay. Can I simply connect the Fibaro output across the relay energising contacts, or will you need a resistor in series to reduce the current?
Question ID: 4192019 Status:
Open Oct 30, 2016 - 10:35 AM
1answer
View More Product Details
Z-Wave Fibaro Double Switch 2
A New Generation of Relay Switch Modules Double Switch 2 was designed to activate and deactivate electrical devices. Thanks to its small size it can be mounted in junction boxes or inside device casings. The module is controlled either through the Z-Wave network or a simple switch. Power and energy ...
See More
View Details
Add New Comment