Vesternet Zigbee 2 Channel Switch - Technical Support - SmartThings

The VES-ZB-SWI-015 is a Zigbee 2 Channel Switch and offers the following features:

  • 3-Wire (with Neutral) wiring
  • 2 Output Channels
  • 2 Switch Input Channels
  • Supports Momentary Switches
  • 5.1A Resistive Load (1.7A Capacitive / Inductive Load) per channel
  • Power, Energy, Voltage & Current Metering (whole device only)
  • Small Installation Size 45.5 x 45 x 20.3 mm
  • Zigbee 3.0 works with ZigbBee ZHA & Zigbee ZLL Hubs & Bridges

 

A manual for this device can be downloaded here.

Vesternet Edge Channel

In order to make the Device Drivers available for your Vesternet Zigbee devices, simply subscribe to the Vesternet Edge Channel.

Here you can enrol your SmartThings hub to the Edge Channel and select which of the available Device Drivers to install.

Note that the Device Drivers are first release versions so while they might not be fully functional featuring all features and capabilities, they should be usable for their primary functions.

It should also be remembered that the SmartThings Edge platform itself is still under development and changes there may unintentionally break third-party Device Drivers.

Please report any issues with the Vesternet Edge Device Drivers by submitting a technical request ticket.

This Vesternet Device has the following features when used with our supporting Edge Device Driver in the SmartThings Smart Home Controller (tested with SmartThings firmware version 000.032.00012).

  • Supports On and Off Control of each channel from the App.
  • Reports On and Off Events for each channel when operated from the local switches.
  • Reports Power, Energy and Voltage Meters for the whole device (SmartThings doesn't currently support the Current capability).
  • Allows assigning of "Actions" for On and Off Control of each channel from the Device Details section of the App.
  • Allows adding of "Automations" for On and Off Events for each channel from the Automations section of the App.
  • Allows adding of "Automations" for Meter Events for the whole device from the Automations section of the App.
  • Allows adding of "Automations" for On and Off Control of each channel from the Automations section of the App.
  • Has configuration options for Meter reporting.